Resolving Whirlpool Dishwasher Error Codes: Troubleshooting Tips and Solutions

34
whirlpool dishwasher error code list

Whirlpool dishwashers are known for their reliability, but occasionally, you may encounter error codes on the display. Understanding these error codes is crucial for resolving the issues. In this article, we will provide a comprehensive list of Whirlpool dishwasher error codes along with suggested solutions to help you troubleshoot and fix the problems.

How to Run a Diagnostic Test

If you encounter an error code, running a diagnostic test can provide more insights into the issue. The steps to run a diagnostic test may vary depending on your Whirlpool dishwasher model. Here’s a general guide:

  • Turn on the dishwasher.
  • Open the door.
  • Press any three keys on the control board quickly.
  • Repeat the same button presses in the same order two more times.
  • Close the door.

Wait for a few seconds, and the dishwasher will enter diagnostic mode. You’ll know the test has started when you hear a buzzing noise. Allow the dishwasher to complete the test cycle before interrupting it. To find the specific instructions for your dishwasher model, refer to the owner’s manual.

Whirlpool Dishwasher Error Code List and Solutions

F1—Unusual water temperature

Solution #1: Check the temperature of your home’s water supply and adjust the water heater temperature if necessary.
Solution #2: Replace the temperature sensor if it’s faulty.

F2—Leaks

Solution #1: Replace the gasket around the dishwasher door if it’s damaged.
Solution #2: Clean the filter assembly to prevent clogging.
Solution #3: Ensure the dishwasher sits flat on the kitchen floor to prevent water leakage.

F3—Heating problems

Solution #1: Replace the heating element if it’s damaged.
Solution #2: Refer to Solution #2 in the F1 error code description.

F4—Draining failure

Solution #1: Clean the filter assembly to prevent clogging.
Solution #2: Unblock the drain line or replace it if necessary.
Solution #3: Replace the drain pump if it’s faulty.

F5—Blocked rotor

Solution: Check the motor for blockages and remove any debris. Consider replacing the motor if the error persists.

F6—Not receiving water

Solution #1: Check the inlet valve and replace it if necessary.
Solution #2: Check the inlet hose for kinks or tears and straighten or replace it accordingly.

F7—Abnormally low water flow rate

Solution #1: Check the inlet valve and replace it if needed.
Solution #2: Check the inlet hose for any issues and straighten or replace it as required.

F8—Too much water

Solution #1: Check the inlet valve and replace it if needed.
Solution #2: Clean the filter assembly to prevent clogging.
Solution #3: Ensure dishes are loaded properly to avoid water retention.

F9—Continuous water intake

Solution #1: Check the inlet valve and replace it if necessary.
Solution #2: Replace the drain pump as described in the F4 error code solution.

F10 or F0—Faulty sensor(s)

Solution: Inspect the sensors one by one to identify the faulty one. Consider using a multimeter or seeking professional assistance for sensor inspection and replacement.

Conclusion

By understanding Whirlpool dishwasher error codes and following the suggested solutions, you can effectively troubleshoot and resolve various issues. If you encounter persistent problems or need further assistance, it’s advisable to consult a professional technician or refer to the manufacturer’s support resources.